Modify place jurisdictions
This windows lets you modify the standard place jurisdictions format of any Gedcom file and also align all places names existing throughout the Gedcom file to this definition.
This definition is saved in the header of the Gedcom file. It is therefore specific to each genealogy file and there is only one for each file.
If you decide to align all place names to the standard format, each place name will be modified accordingly and saved in the Gedcom file.
This panel shows the existing format at the top under "Current format". Where does this current format come from?
- When you first create a genealogy file, Ancestris uses the main language to define the place jurisdictions format.
- When you migrate a Gedcom file from another software, Ancestris will also define the place format if none already exists, unless you do not convert the file when migrating it from this other software. In this case, Ancestris leaves the Gedcom file untouched, and just opens it. The Current format can potentially be empty if the previous software did not use this feature of the Gedcom standard.
Under "Current format" is an indication of how many different locations are found in the Gedcom file, and how many of them are not aligned to the place jurisdiction format. A button appears on the right hand side to let you decide to convert them.
The new format is at the bottom under "New jurisdictions format". If it is different from the current format, a button will appear to let you convert from the current to the new format, by defining the mapping table of the jurisdictions. See below.
The middle part of the panel is to create a new format using the buttons
Here is how to proceed to define or change a place format.
First define the new jurisdictions format
- Use the Add criteria button to enter each of the jurisdictions one by one in the field to the right of this button.
- Use the Remove criteria button on each of the jurisdictions to be removed.
- Use the arrow buttons to order the new jurisdictions from the smallest to largest geographic area.
By the way, the Empty button allows you to insert an empty jurisdiction, and the reset button starts all over again.
The picture below shows an example when changing from the US to the French place format as an illustration.
Next provide the conversion map using the Convert button
Make sure the convert box is checked and click on the Conversion button . This will display a mapping table between the current and new format fields as per the screen below.
The screen explains what to do. It is shown below after dragging and dropping the first 4 American jurisdictions which correspond to four of the French jurisdictions.
If a new jurisdiction does not exist in the current format, it will be empty in the new location.
If a current jurisdiction does not exist in the new format, the corresponding place information will disappear after conversion and data would therefore be lost.
Once this correspondance is established,
If you have changed the format
of the places without checking the conversion box, two situations arise:
- either the number of criteria between the old and the new formats is different: in this case, Ancestris would notify you of an anomaly in all places when checking for anomalies. If you reduce the number of criteria, you will obviously loose the data corresponding to the criteria which have no position in the new format.
- or the number of criteria is the same: in this case, no data will be lost.
By clicking OK on the previous screen, Ancestris will modify all places in the Gedcom file according to the conversion map and will display the following screen.